INFO

SwyxWare v4.30 Hotfix 3 (kb2764)

The information in this article applies to:

  • SwyxWare CD v4.30
  • SwyxWare v4.30

[ Summary | Information ]


Summary

Swyx releases the SwyxWare v4.30 Hotfix 3.

Please note the common hints on hotfixes in the following Knowledgebase article:


Information

This hotfix 1 includes also the hotfixes

  • SwyxWare v4.30 Hotfix 1 (not yet made publicly available)
  • SwyxWare v4.30 Hotfix 2 (not yet made publicly available)

and resolves the following problems:

  • Firmware-Update does not work anymore.
    (Swyx00007299 - Hotfix 1)
     
  • The caller list is not timely ordered.
    (Swyx00006906 - Hotfix 2)
     
  • In a special situation called device continues to ring after ConnectTo times out.
    (Swyx00007307 - Hotfix 2)
     
  • SwyxServer uses non-ascii characters in header when sending voicemails.
    (Swyx00007306 - Hotfix 2)
     
  • "Matching Lines Only" not working when using internal S0 and MSNs.
    (Swyx00007348 - Hotfix 2)
     
  • Protection failure within Linemanager. PhoneManager and SwyxIt! are affected. For this reason you should also install (Swyx00007367 - Hotfix 3)
     
  • Lots of access violations in ConferenceManager caused by a race condition.
    (Hotfix 3)
     
  • Increased max. number blocks/frames in jitterbuffer of ConferenceManager(cause SwyxWare uses 20ms frames from v4.30 on, instead of 30ms frames)
    (Hotfix 3)
     
  • The voice could not be heard with the very first intercom call on the destination.
    (Hotfix 3)
     

Further informations and a detailed installation instruction can be found in the included README.TXT file.


Comment

Comment on this article



If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


Note

This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.